Safe Fence - Installation: Install Safe-Fence Polytape
| Attach polytape to top tensioner on first tensioner post. Run tape through insulators but do not close insulators. Attach to tensioner on second tension post but do not pull tight. Go back to first line post and pull tape tight with one hand while closing insulator with other hand (do not close insulator with a hammer or install in temperatures below 45°F). Repeat procedure for each insulator and then tighten tape at second tensioner. |
 |
 |
NOTE: Do not over-stretch polytape. Just hand-tighten to eliminate sagging between fence posts. |
| Tip: Use R-24 Splicers to connect polytape when you come to the end of a roll. |
 |
|
GO TO SAFE FENCE PRODUCTS
RESOURCES:
PRODUCT OVERVIEW (PDF File)
DESIGN PLANNING CHART (PDF File)
FULL INSTALL GUIDE & REFERENCE MANUAL (PDF File)
INSTALL SECTIONS:
Installation Introduction
Fence Charger Location
Ground Rod Installation
End, Corner & Gate Posts
Line Posts
Tensioners & Insulators
SAFE-FENCE Polytape
Power Up!
Power Across Gates
Improving Ground Systems
|
HOME
powered by